Hydraulic Log Splitter Maintenance Tips
January 22, 2023 by Mark Allinson Leave a Comment
Log splitters are a useful tool to have in your arsenal, so they deserve proper care. Over time, even small issues will build up and create noticeable drops in the efficiency of your log splitter.
If you’re looking for ways to ensure your splitter is kept in optimal condition, then you’ve come to the right place. We will walk through some of the most useful log splitter maintenance tips.
You don’t have to sit down and read every word. You’d probably get so bored that you wouldn’t learn anything. But the maintenance section should definitely get some attention.
Use this section to make a list of general maintenance checks to perform. Since machines vary between brands, there might be maintenance issues not listed in this guide. It’s better to know now than to learn the hard way.
Hoses that extend from the hydraulic tank to the cylinder should be regularly inspected for wear and tear. Just keep in mind that these hoses have a lot of pressure so don’t feel around for leaks.
Limit it to a visual inspection. If you suspect a leak, use a piece of cardboard to check the area. If you find a leak, replace the hose immediately.
Water buildup will contaminate hydraulic fluid over time, so it’s important that you perform a regular inspection. If you notice a milky grey color in the fluid, then it has been contaminated.
This significantly decreases the efficiency of the log splitter and will lead to other problems if left unchecked. Replace contaminated hydraulic fluid as quickly as possible.
The pull cord gets a lot of use, so it will eventually develop wear. Inspect its full length to ensure that it isn’t fraying. If it is, then you need to replace it as quickly as possible. You don’t want the cord breaking when you need it most!
This one is a bit tricky so you will have to take extra steps. The hydraulic pump contains a power take-off coupling that can sometimes get loose. Inspect it at least once a year. Here’s the challenge.
If the coupling is loose, then you have to change the bearings since it’s not feasible to tighten the coupling itself. The pump will eventually fail to start up if the coupling gets too loose.
The ram must be regularly greased in order to ensure proper operation of a log splitter. Plus, the ram will get rusty if it’s not covered in grease. Needless to say, that will damage the whole machine.
If you happen to notice rust on the ram during your inspection, gently sand it off and then apply grease to the affected area. If left unchecked, rust will break the hydraulic seal and lead to expensive damage, and you may end up having to shop for a new log splitter hydraulic cylinder.
This log splitter maintenance tip is only applicable if your machine operates on a gas-powered engine. If so, then you need to inspect it regularly just like you would any other engine.
Check the oil before use and make sure it’s full and that the oil is clean. Low oil levels will lead to expensive engine damage. You also want to inspect the carburetor and spark plugs as part of your scheduled maintenance.
The key is to perform preventative maintenance of your machine to catch small issues before they lead to large, expensive damage.
There are certain indicators that something’s wrong, so never ignore unusual operation. The most common indicator with a hydraulic log splitter is excessive vibration.
Filed Under: Engineering Tagged With: check, cord, coupling, damage, don, engine, expensive, fluid, hydraulic, inspect, inspection, lead, log, loose, machine, maintenance, oil, perform, pump, ram, regularly, replace, splitter
Log splitters are a useful tool to have in your arsenal, so they deserve proper care. Over time, even small issues will build up and create noticeable drops in the efficiency of your log splitter.